Solid State Logic | Support

Quicklinks

Tutorials

Maintenance Procedures

The following videos complement our module exchange service. Each video details the procedure of replacing a particular console assembly enabling you to replace a defective part with confidence.

Important notice: Before attempting any of these procedures, please review the instructions in full to ensure that you have sufficient time and technical skills to complete the exchange. It is the user’s responsibility to ensure they are technically competent. SSL and its subsidiaries cannot accept liability for any loss, damage or injury or any claims in respect of any loss, damage or injury in relation to any of the maintenance procedures detailed below.

If you would prefer an SSL technician to complete the upgrade, please contact your local SSL distributor or office.

These instructions are intended for technically competent personnel. To reduce the risk of electric shock do not perform the exchange unless you are competent to do so.

Ensure that you switch off and disconnect the power cord(s) before removing any panels or modules.

Fader replacement: How to replace the AWS 629924X6 Moving Fader assembly

Fader cleaning: How to clean the AWS 629924X6 Moving Fader assembly

Channel module replacement: How to replace the AWS 629921X1 Channel Strip assembly

Solo and Cut panel replacement: How to replace the AWS 629982X2 Solo and Cut assembly

Channel meter panel replacement: How to replace the AWS 629923X1 Channel Meter assembly

Centre section module replacement: How to replace the 629918X1/2 Dynamics, 629919X3 8 Track bus, and 629919X4 Cue/FX modules

Monitor control panel replacement: How to replace the AWS 629926X1 Monitor Control assembly

CPU replacement: How to replace the AWS 629675X2 CPU assembly